When to Replace the Parts in Your Liquid Kit
Share
A word from your Liquid Insert
I'm four weeks old and I've done 224 pumping sessions. I've been stretched, washed, boiled and squeezed back into the shield eight times a day. I'm tired, and you may have noticed, because your pump isn't pulling the way it did in week one.
That's the insert's side of the story. The rest of this post is ours.
How often should you replace each part?
Every part in the Liquid Kit wears at a different rate, and the rate depends on how often you pump.
| Part | Pumping a few times a week | Pumping 8 times a day |
|---|---|---|
| Liquid Insert | 2–3 months | 2–4 weeks |
| Seal diaphragm | 3–4 months | Every month |
| Shield assembly | Check regularly, replace as needed | Every 6 months |
| Tubing | When moisture gets in, it slips off the pump, or it looks worn | Same |
These numbers are estimates. Your own parts may last longer or wear out sooner, depending on how often you pump, how you clean them and how often you sterilize. Sterilizing after every use puts an insert at the short end of its range, closer to 2 weeks.
Why does the Liquid Insert wear out fastest?
The insert does two jobs. The soft silicone shield moves against your breast on every cycle, and the valve at its tip opens and closes on every cycle too. It's the same work a duckbill valve does in a standard kit, and it wears on the same schedule. Silicone loses its stretch with use, and a valve that has lost its stretch can't hold suction.
How can you tell a part is worn out?
A Liquid Insert is done when its valve looks frayed or stretched, or when suction drops while you pump. A seal diaphragm is done when it looks rippled, torn or warped. A shield assembly is done when it's cracked or warped, or when residue has built up where you can't clean it.

Worn-out parts are the most common reason for a drop in output. If you're pumping less milk than you were a few weeks ago and nothing else has changed, the parts are the first place to look.
How do you make Liquid Kit parts last longer?
Liquid Inserts are fragile, so gentle handling when you wash and assemble them makes a difference. A big pot matters when you sterilize by boiling, because parts that bump into each other can warp. Five minutes at a boil is enough, and the parts can air dry on a clean surface afterward. The tubing and seal cap stay out of the water completely.
Does the warranty cover worn parts?
Liquid Kit parts carry a three-month warranty against defects. Silicone parts wearing out from normal use isn't a defect, so the warranty doesn't cover it.
Replacement parts
- Liquid Kit Insert, pack of 2
- Liquid Kit Seal Diaphragms
- Liquid Kit Shield Assembly
- Liquid Kit Tubing
Our guide to replacing and recycling breast pump parts covers what to do with the old ones.